top of page




Instalation
The airbox is installed in the same way as the original. Use the supplied template if you prefer not to mark and cut the opening freehand.
Insert the cutting template into the airbox. Apply marking dye or a similar substance to the end of the adapter, then test-fit the assembly to mark the position. Cut the opening according to the template.
If required, the template can be glued in place and used as an extension of the intake duct.
Install the Superflow filter and tighten the supplied clamp.
IMPORTANT: Do not overtighten the clamp.
Refit the complete assembly onto the OEM lower airbox housing.
Installation by a certified mechanic is recommended.
bottom of page